Gigabyte Z370 AORUS Gaming 7 - Page 85

- 85 -
Conguring a RAID Set
B-2:InstallationinIntelRSTPremiumWithIntelOptaneSystemAccelerationmode
IftheSATAcontrollerhasbeenconguredinIntelRSTPremiumWithIntelOptaneSystemAccelerationmode,
please follow the steps below:
• An Optane
™
memory cannot be used to accelerate an M.2 PCIe SSD.
• If more than one Optane
™
memory is installed, you can select only one of them to accelerate your SATA-
based boot drive. The other(s) can only be used as data drive(s).
• Do not abruptly remove the Optane
™
memory. Doing so will cause the operating system to stop functioning
correctly.
• If you want to change/remove the Optane
™
memory, you must disable it using the Intel
®
Rapid Storage
TechnologyorIntel(R)OptaneMemoryapplicationrst.
• After enabling the Optane
™
memory, the related BIOS settings will remain even after a BIOS update.
Step 1:
After system restarts, go to the BIOS Setup, make sure CSM
Support under the BIOS menu is disabled.
Step 3:
Enter the operating system, launch the Intel
®
Rapid Storage
Technology utility from the Start menu, and then enable Intel
®
Optane
™
Memory on the Intel
®
Optane
™
Memory screen.
Step 4:
If you install more than one Optane
™
memory, please select
which one you are going to use.
Step 5:
Follow the on-screen instruction to continue the installation and then restart
the system when completed.
Step 2:
Go to Peripherals\SATAAnd RST Conguration and
make sure USE RST Legacy OROM is disabled. If you want
to enable the Optane
™
memory installed in the M2M_32G
connector, set PCIe Storage Dev on Port 17 to RST
Controlled; to enable the Optane
™
memory installed in the
M2A_32G connector, set PCIeStorageDevonPort9 to
RST Controlled; to enable the Optane
™
memory installed
in the M2P_32G connector, set PCIeStorageDevonPort
21 to RST Controlled.