please follow the steps below:
1. After system restarts, go to the BIOS Setup, make sure CSM Support under the BIOS menu is disabled.
2. Go to and make sure is disabled.
If you want to enable the Optane
™
memory installed in the M2A connector, set
9 to RST Controlled.
3. Enter the operating system, launch the Intel
®
utility from the Start menu, and
then enable Intel
®
Optane
™
Memory on the Intel
®
Optane
™
Memory tab.
4. Launch the Intel
®
®
Optane
™
or applications to accelerate using the Intel
®
Optane
™
function. (The Optane
™
memory
used must have at least 32 GB capacity.)
• An Optane
™
memory cannot be used to accelerate an M.2 PCIe SSD.
• Do not abruptly remove the Optane
™
memory. Doing so will cause the operating system to stop
functioning correctly.
• If you want to change/remove the Optane
™
memory, you must disable it using the Intel
®
• After enabling the Optane
™
memory, the related BIOS settings will remain even after a BIOS update.
- 42 -
To Next Page
Loading...
