Gigabyte Z490I AORUS ULTRA - Page 8

Storage Interface  1 x M.2 connector (Socket 3, M key, type 2260/2280 SATA and PCIe x4/x2 SSD
support) (M2A_CPU)
 1 x M.2 connector on the back of the motherboard (Socket 3, M key, type 2260/2280
SATA and PCIe x4/x2 SSD support) (M2M_SB)
 4 x SATA 6Gb/s connectors
 Support for RAID 0, RAID 1, RAID 5, and RAID 10
* Refer to "1-7 Internal Connectors," for the installation notices for the M.2 and SATA
connectors.
 Intel
®
Optane
™
Memory Ready
USB  Chipset:
- 1 x USB Type-C
™
port with USB 3.2 Gen 1 support, available through the
internal USB header
- 1 x USB Type-C
™
port on the back panel, with USB 3.2 Gen 2 support
- 1 x USB 3.2 Gen 2 Type-A port (red) on the back panel
- 6 x USB 3.2 Gen 1 ports (4 ports on the back panel, 2 ports available through
the internal USB header)
- 6 x USB 2.0/1.1 ports (2 ports on the back panel, 4 ports available through
the internal USB header)
Internal
Connectors
 1 x 24-pin ATX main power connector
 1 x 8-pin ATX 12V power connector
 1 x CPU fan header
 3 x system fan headers
 1 x addressable LED strip header
 1 x RGB LED strip header
 4 x SATA 6Gb/s connectors
 2 x M.2 Socket 3 connectors
 1 x front panel header
 1 x front panel audio header
 1 x speaker header
 1 x USB Type-C
™
header, with USB 3.2 Gen 1 support
 1 x USB 3.2 Gen 1 header
 1 x USB 2.0/1.1 header
 1 x Clear CMOS jumper
 1 x chassis intrusion header
Back Panel
Connectors
 1 x DisplayPort
 1 x HDMI port
 1 x USB Type-C
™
port, with USB 3.2 Gen 2 support
 1 x USB 3.2 Gen 2 Type-A port (red)
 4 x USB 3.2 Gen 1 ports
 2 x USB 2.0/1.1 ports
 1 x Q-Flash Plus button
 1 x RJ-45 port
 2 x SMA antenna connectors (2T2R)
 3 x audio jacks
I/O Controller  iTE
®
I/O Controller Chip
- 8 -