- 24 -
11) SATA3 2/3/4/5/6/7 (SATA 6Gb/s Connectors)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device. The Intel
®
Chipset supports RAID 0,
RAID 1, RAID 5, and RAID 10. Please navigate to the "Conguring a RAID Set" page o GIGABYTE's
website or instructions on conguring a RAID array.
Pin No. Denition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
SATA3
3 5 7
2 4 6
To enable hot-plugging for the SATA ports, please navigate to the "BIOS Setup" page of GIGABYTE's
website and search or "SATA Conguration" or more inormation.
1
1
7
7
10) NOISE_SENSOR (Noise Detection Header)
This header can be used to connect a noise detection cable to detect the noise inside the case.
Pin No. Denition
1 Noise Detection
2 GND
Beore connecting the cable to the header, make sure to remove the jumper cap; re-place the
jumper cap i the header is not in use.
For more information on the noise detection function, please navigate to the "Unique Features"
page of GIGABYTE's website and search for "System Information Viewer."
1
Noise Detection
Cable
1
To Next Page
Loading...
