- 9 -
Internal
Connectors
2 x USB Type-C
®
headers, with USB 3.2 Gen 2x2 support
2 x USB 3.2 Gen 1 headers
1 x integrated extension cable header for system fan/water cooling pump and USB
2.0/1.1 headers (can extend one system fan/water cooling pump header and two
USB 2.0/1.1 headers through one cable)
2 x temperature sensor headers
1 x power button
1 x reset button
1 x Clear CMOS button
Back Panel
Connectors
1 x Q-Flash Plus button
1 x OC Ignition button
2 x SMA antenna connectors (2T2R)
2 x Thunderbolt
™
4 connectors (USB Type-C
®
ports, with USB 3.2 Gen 2 support)
10 x USB 3.2 Gen 2 Type-A ports (red)
2 x RJ-45 ports
1 x optical S/PDIF Out connector
2 x audio jacks
* The mic in jack supports only mono microphone input.
I/O Controller iTE
®
I/O Controller Chip
Hardware
Monitor
Voltage detection
Temperature detection
Fan speed detection
Water cooling ow rate detection
Fan fail warning
Fan speed control
* Whether the fan (pump) speed control function is supported will depend on the fan
(pump) you install.
Noise detection
BIOS 1 x 256 Mbit ash
Use of licensed AMI UEFI BIOS
PnP 1.0a, DMI 2.7, WfM 2.0, SM BIOS 2.7, ACPI 5.0
Unique Features Support for GIGABYTE Control Center (GCC)
* Available applications in GCC may vary by motherboard model. Supported functions
of each application may also vary depending on motherboard specications.
Support for Q-Flash
Support for Q-Flash Plus
Support for Smart Backup
Bundled
Software
Norton
®
Internet Security (OEM version)
LAN bandwidth management software
Operating
System
Support for Windows 11 64-bit
Form Factor
E-ATX Form Factor; 30.5cm x 28.5cm
* GIGABYTE reserves the right to make any changes to the product specications and product-related information without
prior notice.
& Please visit the SERVICE/SUPPORT\Utility page on GIGABYTE's website to download the latest version
of apps.
https://www.gigabyte.com/Support/Utility/Motherboard?m=ut
To Next Page
Loading...
