Need help?Do you have a question about the Gilbarco TRANSAC 12A and is the answer not in the manual?
Provides an overview of the Transac 12A system's capabilities and operational functions.
Details on how to install the dispensing units with the Transac 12A.
Guidance on configuring dual H-111 dispensers for the Transac 12A system.
Explains how to set the pump number selector switch for hose assignment.
Details on setting grade selector switches for hose assignments.
Configures Logic Board settings like single/dual, decimal point, and volume unit.
Describes rocker switches replacing straps on later logic boards.
Explains functions of various switches and straps on the logic board.
Configures grade assignments for the 'A' side using JPC jumpers.
Configures grade assignments for the 'B' side using JPC jumpers.
Configures decimal point, volume unit, and single/dual options.
Sets pump numbers for the 'A' and 'B' sides of the H-111B.
Specifies requirements for the installation site of the Transac System.
Outlines necessary steps before actual system installation.
Instructions for inspecting and handling unpacked equipment.
Specifies conduit requirements for dispensing units and wiring.
Provides step-by-step procedures for proper system installation.
Details on securing conduit connections and preventing wire damage.
Guidance on using U/L listed wire connectors for secure connections.
Notes on using foundation layouts and when to apply power.
Refers to drawings for cabling and wiring connections.
Lists the necessary equipment for initial system checkout.
Procedure for testing wire insulation resistance.
Verifies hot wire phasing on the same transformer leg.
Steps for installing the battery in the Transac 12A console.
Procedures to verify operational status of each dispensing unit.
Steps to program Grade 4 hoses for console assignment.
Procedure for purging air from all dispensing unit lines.
Necessary console programming steps for system checkout.
Step-by-step process to verify correct system operation for each hose.
Recording and comparing preset and delivered amounts for transactions.
Verifying pump and console totals against expected values.
Explains the Transac 12A Highline 111 self-service system architecture.
Breakdown of the TRANSAC 12A's seven major component boards and their functions.
Description of the power supply module and its functions.
Explains the role of the Processor Board in system communication and data handling.
Details the circuitry for driving displays and indicator LEDs.
General advice on troubleshooting the T-12A H111 system.
Cautions to follow for a simple and error-free troubleshooting process.
Steps to determine the exact malfunction and potential contributing factors.
Chart detailing fuse ratings, locations, and affected components.
Guidance on following the troubleshooting chart from beginning to end.
Identifies symptoms related to no display and their corrective actions.
Addresses issues with incorrect display readouts and their solutions.
Details problems with incorrect operation and possible causes.
Steps to completely clear the console memory if scrambled.
Procedure to put the console into diagnostic mode.
List of keyboard keys and their corresponding diagnostic codes.
Tests to check the functionality of the Processor Board.
Procedures to verify field wiring and data loop operation.
Steps to check data loop continuity using switches and indicators.
Verifying that each dispenser responds to the console.
Wiring diagram for dual one and two product dispensers.
Important notes and guidelines for dispenser wiring.
Wiring diagram for H-111B standalone pumps.
Table showing circuit loads for dispensing unit components.
General| Brand | Gilbarco |
|---|---|
| Model | TRANSAC 12A |
| Category | Music Mixer |
| Language | English |
To Next Page