5-29
Operation - Advanced Use 5
Value for use with
File Number TASK/Parameter Dual-syringe Model Single-syringe Model
Method 92 Dispense
Sample Source Reservoir (RESV) Reservoir (RESV)
Fractions Same Same
Nb of Fractions 3 3
Common Volume 1000 1000
Method 93 Dispense
Sample Source Probe Probe
Fractions Different Different
Nb of Fractions 3 3
Fraction 1 50 500
Fraction 2 100 700
Fraction 3 200 500
Adjust Source Reservoir (RESV) Reservoir (RESV)
Final Volume 1000 1000
Method 94 Pipette
Fractions Different Different
Nb of Fractions 4 4
Fraction 1 50 300
Fraction 2 80 400
Fraction 3 100 500
Fraction 4 200 600
Running a Method (RUN)
The Run soft-key appears, after you have entered your
Method. Press Run to start the Method currently
shown on the screen. If you want to run a different
program, you must key in its file number and press
ENTER, before pressing Run. In either case a series
of in run screens appears, starting with the in-run
prompts (if any).
In-run Prompts
Values for any parameters defined as in-run prompts
(using a question mark) must be confirmed, or
changed, before the Method runs.
After pressing Run, the software prompts you for
action: you must press ENTER to confirm the value
shown on the screen, or to change it, key in a new
value and then press ENTER.
When the Method runs you must follow the instruc-
tions on the screen. You press the command button
on the probe to aspirate and to dispense, when
prompted to do so by the command light on the probe:
-a steady light means you are to aspirate or dispense
liquid,
- a flashing light means you are to aspirate air via
the probe.
Software
To Next Page
Loading...