Regular inspections
The following parts and materials must be inspected regularly for damage, abrasion and correct
operation, e.g. after landing:
●
Risers and quick-links
●
Lines
●
Fabric
Lines
Measuring the length of the lines is part of the regular paraglider inspection. The lines have a
considerable influence on flight behaviour. Correct line length and symmetry are also important for
performance and handling. Gin Gliders therefore recommends an inspection every 50 to 100 hours or
once a year.
Environmental conditions such as high temperatures or moisture can a
ff
ect line length. Check the
line length regularly, particularly if you notice any change in launch or flight behaviour. The line length
should be checked if you have landed in water or if the lines have got wet through. Lines age and
lose strength even if the paraglider is used infrequently or not at all. This can a
ff
ect the safety and
function of your paraglider.
Signs of wear are slight bumps or changes in flying characteristics. The lines must then be replaced
immediately. Use only inspected and approved lines, which can be obtained through Gin Gliders.
WARNING: A damaged line can result in loss of control of the glider. Always replace lines
which are damaged. If you need to replace damaged or worn-out parts, use only original
parts or approved parts from the manufacturer.
Do not under any circumstances use knots to shorten the lines. Any knot will weaken the
line considerably and may cause the line to break in case of high load. The overhand knot
and bowline knots described are permitted only for connecting the main brake lines/brake
handle.
Inspection periods
Failure to observe the inspection periods shall render invalid the certification and warranty.
A properly completed logbook with details of all flying and training will help you to comply with these
periods.
The following inspection periods apply to the Evora:
●
36 months or after 200 hours (including ground handling), whichever is sooner
●
subsequent inspections should be carried out every 24 months or 150 hours (including
ground handling), whichever is sooner
Ground handling time must be at least doubled when calculating the total hours of use because of
the increased wear and tear on the glider.
If you use the Evora in harsh conditions (sand, dust, stones etc.), we recommend a biannual check.
Gliders in professional or school use should be inspected every 100 flying hours and up to a
maximum of 300 flights, provided these checks occur at intervals no longer than two years.
This recommendation only applies if the wing has been correctly stored and used with regular pilot
inspections (at least every 150 flights). The condition of all components must be tested during the
inspection according to the strictest GIN Inspection Instruction guidelines. Finally the overall condition
of the paraglider should be assessed and recorded.
To Next Page
Loading...
