Step 5 - Charging
Charge your battery for the first time - Your scooter does not arrive fully
charged and will need charging before it is ready to drive. See instructions
for charging on page #.
Step 6 - (Optional Installation) Windshield
The Titan PR includes the previously separate windshield kit at no extra
cost. The windshield is not required for use and is completely optional to
install. Ensure hands are clean and take care with plastic components to
avoid damaging the windshield during installation.
Locate the hardware for the brackets that mount to the acrylic shield panel.
Each side consists of an outer bracket, rubber grommet, rubber washers
(x2), nuts (smaller size x2), an L shaped support and 2 plastic mounting
clips. Begin by sliding 2 mounting clips onto the longer portion of the
support, facing the opposite to the short side of the support.
Next layer the rubber grommet over the threads of the outer bracket and
insert through the premade holes in the acrylic shield. Align the mounting
clips on the L shaped support with the outer bracket threads. (Short side of
the support pointing towards the edge of the shield. Add rubber washers to
the threads before securing each with a nut. Repeat the process for the
other side to complete the windshield body. (See images on next page…)
06
To Next Page
Loading...
Need help?
General
