Safety Instructions For Use
-6-
- Carefully read this manual and familiarize yourself with the
correct procedures before using this unit.
- Use only 12V vehicles for emergency start.
- Handle this device with care.
- DO NOT use this unit if the cables and their terminals are
damaged.
- DO NOT use instead of the vehicle battery.
- DO NOT use to attempt to recharge the vehicle’s battery.
- Never leave this unit connected to the battery after the engine
has been successfully started.
- Only use the cables supplied with this unit for emergency
starting. Make sure that the BLUE plug of the starter cable is
fully inserted into the emergency start socket. Otherwise, the
blue plug will melt.
- Ensure that all clean battery connections and battery terminals
are securely connected before attempting an emergency start.
If the battery terminals of the vehicle are dirty or corroded, the
current supplied from the unit will be reduced.
- DO NOT RUN more than three starts in a row. The unit could
be damaged by overheating. Wait two minutes before trying
again. The emergency charging cable may overheat and
disconnect as a safety precaution.
- Disconnect the unit from the vehicle's battery within 30
seconds after the emergency start. Otherwise, it could be
damaged.
- DO NOT connect two cable terminals to each other.
- Emergency start only when 3 to 4 indicator LED lights are on.
To Next Page
Loading...