52
Glide Adaption Kit
Also, the CentroGlide if not fitted from standard must have the following kit installed.
This kit comprises of pair of leg hanger mounts (L & R side) with 8mm socket screw
added as per Fig12. This acts as an anti-detach for leg hangers. Also 6 x 8mm x 45mm
socket screw with a radius head to replace the existing socket screws as arrows Fig 13
below.
Fig 12
Fig 13
⚠ Warning
The Dahl docking station can be used on CentroGlide models with serial numbers
greater 2203001. Retro fitting maybe possible to earlier models but requires
modifications to the chassis which can only be carried out by an authorised Dahl
installer or Glide Products.
To Next Page
Loading...
