With the scale o we proceed to remove the lid marked with the battery symbol by
sliding it outwards.
Once opened the battery compartment is exposed. Remove this carefully without
damaging the wires of the adjacent weight sensors and replace with a new battery.
Place everything and check the correct operation.
Replacing the battery
Measurements in windy locations are not recommended because they introduce addi-
tional loads on sensors that distort measurements and condition the accuracy of the
device.
Turn o the device after each use. Otherwise the battery can be discharged and will
have to be replaced.
Keep away from heat sources. The material of the device, Polylactic Acid
(PLA) can deform if there are high temperatures so it is not recommended
for example to leave it in the car on sunny or hot days.
Keep away from any contact with water.
Do not exceed the maximum weight supported.
Recommendations
GliderCG
Eng
9
To Next Page
Loading...