Need help?Do you have a question about the Global Specialties 5001 and is the answer not in the manual?
General| Brand | Global Specialties |
|---|---|
| Model | 5001 |
| Category | Timer |
| Language | English |
Details the impedance, response, sensitivity, and voltage limits of the inputs.
Explains the available measurement modes like Frequency, Period, and Ratio.
Outlines the precision and performance standards of the device.
Covers controls, display, power, dimensions, and operating temperature.
Describes the power switch and primary measurement mode selection buttons.
Details RUN, HOLD, RESET, and delay/gate time selectors.
Explains input attenuation, trigger level, and slope selection for signal accuracy.
Describes the internal/external timebase switch and input connector.
Step-by-step guide to verify instrument functionality and initial setup.
Instructions for performing frequency measurements using the instrument.
Instructions for measuring signal period and calculating frequency.
Guide to measuring the ratio between two input frequencies.
Instructions for measuring time between signal edges and pulse widths.
How to use the instrument to count events or signal edges.
Guidelines for adjusting attenuation, trigger level, and slope for optimal signal input.
Explains the function of holding the display and introducing delays between measurements.
Details how to use an external timebase for enhanced accuracy and range.
Procedure for replacing the instrument's fuse.
Steps for recalibrating the instrument's accuracy.
Step-by-step instructions for opening the instrument's case.
Step-by-step instructions for closing the instrument's case.
Examples and guidance for using the instrument as a frequency counter.
Examples of using the instrument for period measurements.
Examples of measuring time intervals and pulse parameters.
Guidance on using the instrument for frequency ratio measurements.
Examples of using the instrument to count events.
Examples of using the external timebase for extended measurements.
Information on obtaining service and repair for the instrument.
Details the warranty terms and conditions for the device.
To Next Page