Global Surgical SMR MAXI Standard User Manual

Section 4 Operating Instructions
4-5
4.6.1. Powering Up the Drawer Warmer
To Operate the Drawer Warmer
1. Turn on the power switch by pressing the push button switch. The LED ring on the switch will light up
indicating that the warming operation has turned on. The drawer will heat to 98.06°F 37°C ±2°. Push the
button switch again and the lighted ring on the power button switch will go out indicating that the warming
operation has shut o󰀨.
4.7. Optional S 740254KP Keyless Locking System
4.7.1. How to Operate the S 740254KP Keyless Locking System
The S 740254KP Keyless Locking System is powered by 2 AAA batteries (installed).
1. To UNLOCK: Type the 4-digit user code, press ENTER, and rotate knob clockwise 180 degrees.
2. To LOCK: Rotate the knob counter-clockwise 180 degrees.
See Section 5.6 for instructions on how to replace the batteries.
See the manufacturer’s user manual (PN: 333153000000) to set a new user code or for further instructions..
4.6. Optional S 740258A Drawer Warmer
Rotate knob clockwise to
unlock and
counter-clockwise to lock
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
9
9
0
0
LOW
BATT
ENTER
ENTER
CLEAR
CLEAR
CLEAR button
erases any key
input made in
error
Green Indicator
Light indicates
input and valid
code
Yellow Indicator
Light indicates
battery or
program mode
Red Indicator Light
indicates incorrect
entry
ENTER button
is used after
numbers are
selected
Figure 4-8. Keyless Locking System
CAUTION
!
Do not remove instrument tray from drawer warmer during use.
WARNING
Do not try to repair the drawer warmer. Call Global Surgical Technical Service for service
information.
NOTE
!
The drawer warmer has an automatic time out after 9 hours and will shut o󰀨.
To re-start simply press the drawer warmer power button again.
Figure 4-7 Drawer Warmer
POWER
BUTTON
LED RING

Global Surgical SMR MAXI Standard Specifications

General

Brand	Global Surgical
Model	SMR MAXI Standard
Category	Medical Equipment
Language	English