Planning Installation
Compare all parts with the “Hardware Included” section. If any part appears missing or damaged, do not install this product and contact the Customer
Service team at 1-888-543-1388 or e-mail to info@globe-electric.com.
Hardware Included
NOTE: Hardware is not shown to actual size.
CONNECTING INSTRUCTIONS
Item
LED lamp
polarized plug
1
1
Quantity
QR
Please keep these instructions
in a safe place. This is the only
duplicate of the unique QR
code for your product. You
may need it to reconnect the
product to your account or
transfer it to another account.
our YouTube channel, on the
Globe Smart Home - Amazon
1. Download the Amazon Alexa app.
2. Power on your device.
Ensure your device has been installed correctly by following the instructions in the “Installation” section.
3. Scan barcode
• Launch the Amazon Alexa app.
• Select “Add a Device.”
• Select “Light,” locate Globe Electric and follow the in-app instructions on how to scan the 2D barcode.
Please note: The device is automatically in pairing mode for 5 minutes once powered on. If it does not turn
on within 5 minutes, turn the device OFF and ON again to re-enter pairing mode.
FUNCTIONALITY
Voice control with Alexa
• ON/OFF
• Dimming
• Shades of white
• Colors
• Moods
Using the Amazon Alexa app on a mobile device
With the Amazon Alexa app, you can easily manage your home set-up and directly control your Globe Electric lights.
• ON/OFF
• Dimming
• Shades of white
• Colors
• Out of home control
• Add your lights to Alexa Routines
• Add your lights to Alexa Guard
Don’t have a barcode?
Select "Don't have a barcode?" in the Alexa app and follow the in-app instructions on how to connect without a 2D barcode.
How to factory reset device
If you are struggling to set up your device, or if the device was already connected to a network, perform a factory reset by following the
instructions below:
1. Turn device ON for 10 seconds by connecting the power adapter.
2. Turn device OFF and ON 5 times by disconnecting and re-connecting the power adapter. The light will flash RED and then the light will change to
WHITE. When the light changes to WHITE, this means the factory reset mode was successful.
3. Scan the inner barcode (located in the instruction manual) and connect within 5 minutes. If you fail to connect within the 5-minute time frame, turn
device OFF and ON again once to re-enter pairing mode.
The light will flash WHITE to indicate that the pairing was successful.
LED lamp polarized plug with an ON/OFF switch
To Next Page
Loading...
Need help?
General
