PW-R
(Power)
The
PWR
button turns your system on and
off.
AM-ST
Button
Push this button if you want
AM
stereo.
(“STEREO”
will be displayed
when you are receiving an
AM
stereo station.)
Cr02 Button
The
Cr02
button lets you set the system for the type of cassette being used.
If you are using chrome or metal tapes, push the
Cr02
button in. If you are
using standard iron tapes, make sure the button is out.
DNR@
Your audio system has automatic Dynamic Noise Reduction. It helps
remove background hiss noise from the radio or tape player.
DNR@ is
a
registered trademark of the National Semiconductor
Corporation.
Pushbuttons
The four pushbuttons let you return to favorite stations.
You can set the pushbuttons for up to eight favorite stations
(4
AM
and
4
FM).
Just:
Tune in the station.
Push
SET. (SET
appears
in
the
VF
display for a
few
seconds.)
0
Within
5
seconds, push one of the four pushbuttons. Whenever you
push that button, the preset station will return.
Repeat these steps for each pushbutton.
NOTE:
You can preset
3
more stations
on
each band
by
pushing a pair
of
buttons
next to each other at the same time. Just:
Tune in the station.
Push
SET. (SET
appears
in
the
VF
display for
a
few seconds.)
Within
5
seconds, push two buttons next to each other at
the
same time.
Whenever you push that pair
of
buttons, the preset station will return.
Repeat these steps for each pair of buttons.
SCAN Button
When you push this, the radio will
go
to the next station and stay there a
few
seconds. Then it will go to the next station and pause, and keep doing
that. Press
SCAN
again to stop scanning.
SEEK
Button
This chooses stations also, but
it
doesn’t keep moving as
SCAN
does. When
you push
SEEK,
the
radio
goes
to
the next station
and
stays there.
3-17
To Next Page
Loading...
