Turn and Lane Change Signals
The turn signal has twio upward (for right) and two
downward (for left) positions. These positions allow
you
to
signal a turn or
LI
lane change.
To
signal a tum, move the lever
all
the way up or down.
When the turn is finished. the lever will return automatically.
An arrow on the instrument
panel will flash
in
the
direction
of
the turn
or lane change.
To
signal a lane change, just raise or lower the lever
unt.il
the arrow starts
to
flash.
Hold
it
there
until
you
complete
your
lane change. The lever
will
return by
itself when
you release it.
As
you
signal a turn or
a
lane change,
if
the arrows don't
flash but just stay
on,
a signal bulb may be
burned
out
and other drivers won't see your turn signal.
If
a
bulb
is
burned out, replace
it
to help
ac.oid
an
accident.
If
the arrows don't
go
on
at all when you
signal
a
turn, check the fuse (see "Fuses and Circuit
Breakers"
in
the Index) and for burned-out bulbs.
If
you have
a
trailer towing option with added wiring for
the trailer lamps.
a
different turn signal flasher
is
used.
With this flasher installed, the signal indicator will flash
even
if
;I
turn signal bulb is burned
out.
Check
the
front
and rear turn signal
lamps
regularly to make sure they
are working.
Headlamp HighLow Beam Changer
To
change the headlamps from low-beam to high or
high
to
low.
pull the multifunction lever all the way
toward you. Then release
it.
2-39
To Next Page
Loading...
