In addition to the four stations already set, up to three
more stations may be preset on each band by pressing
two adjoining buttons at the same time. Just:
1.
Tune
in
the desired station.
2.
Press
SET.
(SET will appear on the display.)
3.
Press two adjoining pushbuttons at the same time,
within five seconds. Whenever you press the same
two buttons, the station you set will return.
4.
Repeat the steps for each pair of pushbuttons.
Setting the Tone
BASS:
Slide this lever up or down to increase Or
decrease bass.
TREBLE:
Slide this lever up or down to increase or
decrease treble.
If
a station is weak or noisy, you may
want to decrease the treble.
Adjusting the Speakers
BAL:
Turn the control behind the upper knob to move
the sound to the left or right speakers. The middle
position balances the sound between the speakers.
FADE:
Turn the control behind the lower knob to move
the sound to the front or rear speakers. The middle
position balances the sound between the speakers.
Playing a Cassette Tape
Your tape player is built to work best with tapes that are
30
to
45
minutes long on each side. Tapes longer than
that
are
so thin they may not work well in this player.
Once the tape is playing, use the
PWR-VOL,
BAL
and
FADE
knobs just as you do for the radio.
A
lighted
arrow will be displayed to show tape play direction.
FORWARD:
Press the arrow button in the direction that
the lighted arrow points to advance quickly to another
part of the tape. Press STOP-EJECT lightly to stop
forwarding and play the tape.
REVERSE:
Press the arrow button in the opposite
direction that the lighted
arrow
points to reverse quickly
to another part of the tape. Press STOP-EJECT lightly
to stop reversing and play the tape.
PROG:
Press this knob to go from one side of the tape
to the other.
STOP-EJECT:
Press this button to remove the tape or
stop playing the tape in order to play the radio. If you
leave a cassette tape in the player while listening to the
radio, it may become warm.
To Next Page
Loading...
