Removing the Spare Tire
and
Tools
The jacking equipment you’ll need is stored by your
vehicle’s rear doors, along the passenger side wall.
Remove your jack cover by pulling it away from the
side wall and down to release the tabs securing the top
of
the cover.
Remove the wheel blocks by turning the top nut
counterclockwise. Remove the nut and washer, then pull
the wheel blocks off the bolt. Push down
on
the bolt and
remove the hooked end from the slot. Slide the jack
toward the front
of
the vehicle and lift it from the
mounting. Remove the extension and the ratchet from
the pouch.
5-24
To Next Page
Loading...
