GMC 1997 Suburban - Turn Signal and Lane Change Indicator; Headlamp Highlow Beam Changer

Turn Signal and Lane Change Indicator
The turn signal has two upward (for right) and two
downward (for left) positions. These positions allow
you
to signal a turn or a lane change.
To signal a turn, move the lever all the way up or down.
When the
turn is finished, the lever will return automatically.
An arrow on the instrument
panel will flash in the
direction
of the turn
or lane change.
IO signal a lane cnange, just raise or lower the lever
until the arrow starts to flash. Hold it there until you
complete your lane change. The lever
will return by
itself when
you release it.
If you move the lever all the way up or down and the
arrow flashes at twice
the normal rate, a signal bulb may
be burned
out and other drivers may not see your
turn signal.
If a bulb is burned out, replace it to help avoid an
accident.
If the arrows don’t go on at all when you
signal a turn, check for burned-out bulbs and a blown
fuse (see “Fuses” in the Index).
Headlamp HighLow Beam Changer
To change the headlamps from low beam to high or high
to low, pull the turn signal lever all the way towards you.
Then release
it.
When the high beams are
on, this light on the
instrument panel also will
be on.
2-34