In addition to the four stations already set, up to three
more stations may be preset on each band by pressing
two adjoining buttons
at
the same time. Just:
1. Tune
in
the desired station.
2.
Press SET.
(SET
will appear
on
the display.)
3.
Press two adjoining buttons at the same time, within
five seconds. Whenever you press the same two
buttons, the station you set will return.
4.
Repeat the steps for each pair
of
pushbuttons.
P.SCAN:
Press both SEEK buttons to scan through each
of
your preset stations. The system will scan through
and play each preset station stored on your pushbuttons
for a few seconds. Press either SEEK button or
RECALL to stop scanning through the preset stations.
Setting the Tone
BASS:
Slide this lever up or down to increase
or
decrease bass.
TREB:
Slide this lever up or down
to
increase or
decrease treble.
If
a station
is
weak or noisy, you may
want
to
decrease the treble.
Adjusting the Speakers
BAL:
Turn the control behind the upper knob to move
the
sound
to
the
left or right speakers. The middle
position balances
the
sound between the speakers.
FADE:
Turn the control behind
the
lower knob
to
move
the sound to the front or rear speakers. The middle
position balances the
sound
between the speakers.
3-14
To Next Page
Loading...
