Playing a Cassette Tape
Your tape player is built to work best with tapes that are
30
to
45
minutes long on each side. Tapes longer than
that are
so
thin they may not work well
in
this player.
Once the tape is playing, use the knobs for VOLUME,
BAL FADE,
BASS
and
TREB
just as
you
do for
the
radio.
REV:
Press the SEEK left arrow
to
reverse the casserre
tape. Press the SEEK right arrow
to
stop reversing
the tape.
FWD:
Press the SEEK right arrow to advance
the
cassette tape. Press the SEEK
left
arrow
to
stop
forwarding
the
tape.
RECALL:
Press this knob
to
switch tape sides.
EJECT
Press this button to remove the tape or stop the
tape and play the radio.
If
you leave a cassette tape
in
the
player while listening to the radio, it may become wann.
CLN:
If
this message appears on the display, the
cassette tape player needs to be cleaned.
It
will still play
tapes, but
you
should clean it as soon as possible to
prevent damage to the tapes and player. See “Care of
Your Cassette Tape Player” in
the
Index. After you clean
the player, press and hold EJECT for five seconds to
reset the
CLN
indicator. The radio will display
---
to
show the indicator was reset.
AM-FM
Stereo with Cassette Tape and
Automatic Tone Control
(If
Equipped)
Playing the Radio
PWR-VOL:
Press this knob to turn the system on and
off.
To increase volume, turn the knob clockwise. Turn
it counterclockwise to decrease
volume. The knob
is
capable
of
being rotated continuously.
RECALL:
Display the time with the ignition
off
by
pressing this button. When the radio
is
playing, press
this button to recall the station frequency.
3-15
To Next Page
Loading...
