Shifting
from
4LO
to
4HI
or
2HI
To shift from 4LO to 4HI or 2H1, your vehicle must be
stopped or moving less than 3 mph (4.8
km/h)
with the
transmission in NEUTRAL
(N)
or the clutch pedal
engaged. The preferred method for shifting out of 4LO
is to have your vehicle moving
1
to
2
mph
(1.6
to 3.2
km/h).
Press and release the 4HI switch. You must wait
for the 4HI indicator light to stop flashing and remain
illuminated before shifting your transmission into gear
or releasing the clutch pedal.
If
the 4HI switch is pressed when your vehicle is in gear
and/or moving, the 4HI indicator light will flash for
30
seconds but not complete the
shift
unless the vehicle
is moving slower than 3 mph (4.8
km/h)
and the
transmission is in NEUTRAL
(N)
or the clutch
pedal engaged.
On automatic transmission equipped vehicles, if your
transfer case does not shift into 4HI, your transmission
indicator switch may require adjustment. With your
transmission
in
NEUTRAL
(N),
press and release the
4HI switch. While the 4HI indicator light is flashing,
shift your transmission into PARK (P). Wait until the
4HI indicator light remains illuminated before shifting
your transmission into gear.
This
will get you into 4H1,
but you should take your vehicle in for service
to
restore
normal operation.
Windows
Manual Windows
Turn the hand crank on each door to raise or lower your
manual side door windows.
Power Windows
(If
Equipped)
If you have the optional power windows, the controls
are on each of the side doors. With power windows, the
switches control the windows when the ignition is
on
or
when Retained Accessory Power (RAP) is present. (See
“Retained Accessory Power” in the Index.) The driver’s
door has a switch for the passenger windows as well.
2-31
To Next Page
Loading...
