Windshield Wipers
I
You control the windshield wipers by turning the band
with the wiper symbol
on
it.
For a single wiping cycle, turn the band
to
MIST. Hold
it there until
the
wipers start, then let go.
The
wipers will
stop after
one
wipe. If you want more wipes, hold the
band on MIST longer.
You can set the wiper speed for a long or short delay
between wipes. This can be very useful
in
light rain or
snow.
Turn
the band
to
choose the delay time. The
closer
to
LO,
the shorter
the
delay.
For steady wiping at low speed, turn the band away
from
you
to
the
LO
position. For high-speed wiping,
turn the band further,
to
HI.
To
stop
the wipers, move
the band to the
OFF
position.
Be sure to clear ice and snow from the wiper blades
before using them.
If
they’re frozen
to
the windshield,
carefully loosen or thaw them. If your blades
do
become
worn or damaged, get new blades or blade inserts.
Windshield Washer
There
is
a paddle marked with the windshield washer
symbol at the top of the multifunction lever. To spray
washer fluid
on
the windshield,
push
the paddle. The
wipers
will
clear the window and then either stop
or
return
to
your
preset speed.
I
I
I
I-
I
In freezing weather, don’t use your washer until
the windshield is warmed. Otherwise the washer
fluid can form ice on the windshield, blocking
your vision.
To Next Page
Loading...
