This device complies
with
Part
15
of
the
FCC
Rules.
Operation
is
subject to the following two conditions:
(1)
this
device may
not
cause harmful interference,
and
(2)
this device must accept any interference
received, including interference that may cause
undesired operation.
This device complies with RSS-2
10
of Industry and
Science Ca.nada. Operation
is
subject
to
the following
two conditions:
(1)
this device may not cause
interference, and
(2)
this device must accept any
interference, including interference that may cause
undesired operation of the device.
Changes and modifications
to
this system by other than
an authorized service facility could void authorization
to
use this equipment.
Programming the Transmitter
Do
not use the transmitter with any garage door opener
that does not have
the
“stop and reverse” feature. This
includes any garage door opener model manufactured
before April
1,
1982.
Be
sure that people
and
objects are clear
of
the
guruge
door
you
are
progranming!
Your vehicle’s engine should be turned
off
while
programming
the
transmitter.
Follow
these steps to
program up
to
three channels:
1.
2.
3.
4.
If
you have not previously programmed
a
universal
channel, proceed to Step
2.
Otherwise, hold down
the two outside buttons on
the
universal transmitter
until the red light begins to flash rapidly
(approximately 20 seconds). Then release
the
buttons. This procedure initializes the memory and
erases any previous settings for
all
three channels.
Hold
the end
of
the hand-held transmitter against the
bottom surface of the universal transmitter
so
that
you can still
see
the red light.
Decide which
one of
the three channels
you
want to
program. Using both hands, press the hand-held
transmitter button and
the
desired button on the
universal transmitter. Continue
to
hold both buttons
through Step
4.
Hold down both buttons
until
you
see the red light
on
the universal transmitter flash rapidly. The rapid
flashing, which could take up
to
90 seconds,
indicates that
the
universal transmitter has been
programmed. Release both buttons once the light
starts to flash rapidly.
2-61
To Next Page
Loading...
