4.
5.
6.
Press the training button
on
the garage door opener
receiver for one
to
two seconds.
Return
to
your vehicle and press the programmed
button
on
the universal transmitter
until
the red light
flashes rapidly (about two seconds).
Release
the
button, then press it again to confirm it
was programmed
to
the
garage door opener receiver.
You
may
now
use either
the
universal transmitter or
the
hand-held transmitter
to
open your garage door. If
you
still have difficulty
in
programming and require
assistance, please call 1-800-355-35
15.
Erasing Channels
To
erase all three programmed channels, hold down the
two outside buttons until
the
red light begins
to
flash.
Individual channels cannot be erased, but can be
reprogrammed using the procedure for programming the
transmitter explained earlier.
Accessories
Accessories for the universal transmitter are available
from the manufacturer of
the
unit.
If you would like
additional information, please call 1-800-355-35 15.
2-63
To Next Page
Loading...
