The following steps will tell you how to use the jack and
change a tire.
Removing the Spare Tire and
Tools
The jacking equipment you’ll need is stored along the
driver’s side inner rear quarter panels. In some cases,
you may have to remove the spare tire in order to reach
the jack. Your vehicle is also equipped with work gloves
and a plastic ground mat to assist in the changing of a
flat tire.
To remove your
jack
cover,
pull up on the latch(es) on
the cover. Remove the
wheel blocks, jack and
wheel wrench.
The following instructions explain how to remove the
spare tire, depending on where it is mounted on
your vehicle.
NOTICE:
Never remove or restow a tire frondto a stowage
position under the vehicle while the vehicle
is
supported
by
a jack. Always tighten the tire
fully against the underside of the vehicle
when restowing.
5-22
To Next Page
Loading...
