Two-Piece
Front
Thrn
Signal
Lamp
Assembly
1.
Remove the headlamp assembly as shown under
“Two-Piece Composite Headlamp System’’ earlier
in
this section.
2.
Locate the locking
tabs on the
assembly. Squeeze
the tabs together
and push that end
of
the assembly out
while holding the
tabs. The assembly
will swing out.
3.
Unplug the electrical connector.
4.
Turn the harness bulb socket to the left to remove it.
5.
Push the new bulb into the socket until it snaps
6.
Put the new bulb into the headlamp lens assembly
into place.
and
turn
it
to the right until it is tight.
7.
To
replace the assembly, snap the outboard end of
the lamp assembly back into the vehicle. Then swing
the assembly in and snap it into place.
6-37
To Next Page
Loading...
