Audio
Systems
AM-FM Stereo
Your
Delco
Electronics audio system has been designed
to operate easily and give years
of
listening pleasure.
You will get the most enjoyment out of it if you acquaint
yourself with it first. Find
out
what your Delco
Electronics system can do and how to operate all its
controls, to be sure you're getting the most
out
of the
advanced engineering that went into it.
Setting the Clock
for
Systems without
Automatic Tone Control
Press SET. Within five seconds, press and hold the
SEEK
right
arrow
until the correct minute appears
on
the display. Press and hold
the
SEEK
left arrow until the
correct hour appears on the display.
Setting the Clock for Systems with
Automatic Tone Control
rress and hold
HR
until the correct hour appears on the
display. Press and hold
MN
until the correct minute
appears on
the
display.
To
display the clock with the
ignition
off,
press
RECALL
or
HR/MN
and the time
will be displayed for
a
few seconds. There is an initial
two-second delay before the
clock
goes into the
time-set mode.
Playing the Radio
VOLUME:
This knob turns the system on and off and
controls the volume. To increase volume and turn the
radio on, turn the knob to the right. Turn
it
to the left to
decrease volume.
RECALL:
Display the time with the ignition off by
pressing the recall knob. When the radio is playing,
press this knob to recall the station frequency.
Finding a Station
AM-FM:
Press the lower knob to switch between
AM
and FM. The display shows your selection.
3-6
To Next Page
Loading...
