Indicator lights
in
the switches show which setting
you
are
in. The indicator lights will come on briefly when you turn
on the ignition and one
will
stay on.
If
the lights do not
come on, you should take your vehicle
to
your dealer for
service. An indicator light will flash while shifting the
transfer case.
It
will remain illuminated when the shift
is
complete.
If
for some reason the transfer case cannot make
a requested shift,
it
will return to the last chosen setting.
If
the
SERVICE
4WD light stays on, you should take
your vehicle to your dealer for service. See “Service
4WD”
in
the
Index for further information.
Shifting
to
4HI
or
AUTO
4WD
Press and release the 4HI or AUTO 4WD switch. This
can be done at any speed, and the indicator light will
flash while shifting.
It
will remain illuminated when the
shift is completed.
Shifting
to
2HI
Press and release
the
2HI switch. This can be done at
any speed.
Shifting to
4LO
release the 4LO switch. You must wait for the 4LO
indicator light to stop flashing and remain illuminated
before shifting your transmission
in
gear.
If
the 4LO switch is pressed when your vehicle is
in
for
30 seconds and
not
complete the shift unless your
vehicle is moving less than
3
mph (4.8 km/h)
and
the
transmission is
in
NEUTRAL
(N).
After
30
seconds the
transfer case will return to the setting last chosen.
a
oear and/or moving, the 4LO indicator light will flash
Shifting Out
of
4LO
To shift from 4LO to 4H1, AUTO 4WD or 2HI your
vehicle must be stopped or moving less than
3
mph
(4.8 km/h)
with
the
transmission
in
NEUTRAL
(N)
and
the
engine running. The preferred method for shifting
out of4LO is
to
have your vehicle moving
1
to 2
mph
(,
1.6
to
3.2 kndh). Press and release the 4H1, AUTO
4WD or 2HI switch. You must wait for the
4H1,
AUTO
4WD or
2H1
indicator light to stop flashing and remain
illuminated before shifting your transmission into gear.
To
shift to 4L0, the vehicle’s engine must be running and
the vehicle must be stopped or moving less than
3
mph
(4.8
km/h)
with
the
transmission
in
NEUTRAL
(N).
The
preferred method for shifting into 4LO is to have your
vehicle moving
I
to 2 mph
(1.6
to 3.2 km/h). Press and
2-23
If
the 4H1, AUTO 4WD or
2HT
switch is pressed when
your vehicle is
in
gear and/or moving, the 4H1, AUTO
4WD or 2HI indicator light
will
flash for 30 seconds but
will not complete the shift unless your vehicle
is
moving
less than
3
mph (4.8 km/h) and the transmission is
in
NEUTRAL
(N).
To Next Page
Loading...
