Turn
Signal and Lane Change Indicator
If
a
bulb is burned out, replace
it
to help avoid an
accident.
If
the arrows don’t
go
on at all when you
signal a turn, check for burned-out bulbs and a blown
The
turn
signal has two upward (for right) and two
downward (for left) positions. These positions allow you
fL,se
(see 66Fuses,7
in
the
Index).
to
signal a turn or a lane change.
To signal
a turn, move the lever all the way
up
or
down.
Headlamp Highkow-Beam Changer
When the turn is finished, the lever will return autornatically.
T~
change t11e headlalnps from
low
bean1
to
high or high
to low, pull the
turn
signal lever all the way toward you.
An arrow on the instrument
Thell
re,ease
it.
panel will flash
in
the
direction
of
the
turn
or
lane change.
When the high beams are
on,
this light on
the
instrument panel also will
be on.
I-
_,_
-
1
To
signal a lane change, just raise or lower the lever
until
the arrow starts to flash. Hold it there
until
you
complete your lane change. The lever will return by
itself when you release it.
If
you move the lever all the way
up
or down and the
arrow flashes at twice
the
normal rate, a signal bulb
may be burned
out
and other drivers
may
not see your
turn signal.
2-34
To Next Page
Loading...
