FWD
(6): Press this button to rapidly forward the tape
to
the
end of the cassette or until you press
FWD
again.
The radio will play the last selected station while
forwarding
the
tape. The tape direction arrow will blink
during the forward operation.
AM-FM:
Press this button
to
switch from a tape
to
the
radio.
TAPE
AUX:
Press this button to return to the tape
player when playing the radio. The lighted arrow will
appear and show the direction
of
play when a tape is
in
the active mode.
EJECT
Press
this
button to remove the tape. The
radio
will
now play. EJECT can be used with either the
ignition or radio off.
To
load
a
cassette tape with the
ignition or radio
off,
press
EJECT
before loading
the cassette.
CLN:
If this message appears on the display, the
cassette tape player needs to be cleaned. It will still play
tapes, but you should clean
it
as
soon as possible
to
prevent damage to the tapes and player. See “Care of
Your Cassette Tape Player”
in
the Index. After you clean
the player, press and hold EJECT for five seconds to
reset the
CLN
indicator. The radio will display
---
to
show the indicator was reset.
CD
Adapter
Kits
It is possible to use a
CD
adapter kit with your cassette
tape player after activating
the
bypass feature on your
tape player.
To
activate the bypass feature,
the
ignition must be on.
Turn yo~lr radio off. Press TAPE
AUX
and hold for
three seconds. After three seconds, the tape symbol in
the display
will
flash for two seconds indicating the
feature is active. Insert the adapter cassette. It will
power up the radio and begin playing.
This override routine will remain active
until
EJECT
is
pressed.
3-18
To Next Page
Loading...
