GMC 1998 Yukon - Removing the Flat Tire and Installing the Spare Tire

If your vehicle has wheel
nut caps, use the wheel
wrench and ratchet to
remove them. Turn the
wheel wrench to the left,
with
DOWN facing you, to
remove the wheel
nut caps.
Then take off the hub cap.
If the wheel also has a trim ring, use the wheel wrench
to
pry along the edge and remove it.
If the wheel has a smooth center piece, place the wheel
wrench
in the slot on the wheel and gently pry off.
Removing the Flat Tire and Installing the
Spare Tire
1.
Use the ratchet and
wheel wrench to loosen
all the wheel nuts. Turn
the wheel wrench to the
left, with DOWN facing
you, to loosen the wheel
nuts. Don’t remove the
wheel nuts yet.
2. If the flat tire is on the rear of the vehicle, put the
jack handle extension on the jack handle.
5-28