6-40
4. If a CHMSL bulb is replaced, put the new bulb into
the socket and press it in until it is tight. If a cargo
lamp is replaced, put a new cargo lamp bulb into the
socket and press it in until it is tight before turning
the socket clockwise.
5. Put the bulb holder back plate into the lamp housing.
6. Reinstall the lamp assembly and tighten the screws.
Taillamps
1. Open the tailgate.
2. Remove the two
rear lamp assembly
screws near the tailgate
latch and pull out the
lamp assembly.
To Next Page
Loading...
