GMC 2002 Yukon Denali - Turn and Lane Change Signals

2-31
Turn Signal/Multifunction Lever
The lever on the left side of the steering column
includes the following:
D Turn and Lane Change Signals
D Headlamp High/Low-Beam Changer
D Flash
-to-Pass feature
D Windshield Wipers
D Windshield Washer
D Cruise Control
Turn and Lane Change Signals
The turn signal has two upward (for right) and two
downward (for left) positions. These positions allow you
to signal a turn or a lane change.
To signal a turn, move the lever all the way up or down.
When the turn is finished, the lever will return automatically.
An arrow on the instrument
panel cluster will flash in
the direction of the turn or
lane change.
To signal a lane change, just raise or lower the lever
until the arrow starts to flash. Hold it there until you
complete your lane change. The lever will return by
itself when you release it.
If you move the lever all the way up or down, and the arrow
flashes at twice the normal rate, a signal bulb may be burned
out and other drivers may not see your turn signal.
If a bulb is burned out, replace it to help avoid an
accident. If the arrows don’t go on at all when you
signal a turn, check for burned
-out bulbs and a blown
fuse (see “Fuses and Circuit Breakers” in the Index).