Setting Cruise Control
1.
Move the cruise control switch
to
on.
2.
Get up
to
the speed you want.
3.
Press in the set button at the end of the lever and
4.
Take your foot off the accelerator pedal. The
release it.
accelerator pedal will not go down.
CRUISE
United States
Canada
The CRUISE light on the instrument panel cluster will
come on when the cruise control is engaged.
Resuming a Set Speed
Suppose you set your cruise control at a desired speed
and then you apply the brake. This,
of
course, shuts
off
the cruise control. But you don’t need to reset it.
Once you’re going about
25
mph
(40
km/h) or more, you
can move the cruise control switch briefly from on
to
resume/accelerate.
You’ll
go
right back up
to
your chosen speed and
stay there.
If
you hold the switch
at
resume/accelerate, the vehicle
will keep going faster until you release the switch or
apply the brake.
So
unless you want
to
go
faster, don’t
hold the switch at resume/accelerate.
Increasing Speed While Using Cruise
Control
There are two ways to go
to
a
higher speed:
Use the accelerator pedal
to
get
to
the higher
speed. Press the button at the end of the lever,
then release the button and the accelerator pedal.
You’ll now cruise at the higher speed.
resume/accelerate. Hold it there until you get up
to
the speed you want, and then release the switch.
To increase your speed in very small amounts,
move the switch briefly
to
resume/accelerate.
Each time you
do
this, your vehicle will
go
about
1
mph
(1.6
km/h) faster.
Move the cruise switch from on
to
3-1
2
To Next Page
Loading...
