Timer
Trip
Information
Use the trip information button to scroll through the
odometer, TRIP
A,
TRIP B and TIMER.
Odometer
Press the trip information button until the odometer
appears on the display. This shows the total distance
the vehicle has been driven in either miles or kilometers.
Pressing the reset stem located on the instrument
cluster with the vehicle
off will also display the odometer.
Trip
A
and Trip
B
Press the trip information button until TRIP
A
or TRIP
B
is
displayed. This shows the current distance traveled
since the last reset for each trip odometer in either miles
or kilometers. Both odometers can be used at the
same time.
Each trip odometer can be reset to zero separately by
pressing select while the desired trip odometer is
displayed. You can also reset the trip odometers with
the reset stem on the cluster. If you press and hold the
reset stem for four seconds, the display will show the
distance traveled since the last ignition cycle.
The
DIC
can be used as a stopwatch. Press the select
button while TIMER is displayed to start the timer.
The display will show the amount
of time that has
passed since the timer was last reset (not including time
the ignition is
off).
Time will continue to be counted as
long as the ignition
is
on, even
if
another display is being
shown on the
DIC. The timer will record up
to
99 hours,
59 minutes and 59 seconds (995959) after which
the display will roll back to zero.
To stop the counting of time, press the select button
briefly while TIMER is displayed.
To reset the timer to zero, press and hold the select
button while TIMER is displayed.
3-51
To Next Page
Loading...
