DlSP (Display): Press this knob
to
see how long the
current track has been playing. ET and the elapsed time
will appear on the display. To change the default on
the display (track or elapsed time), push the knob until
you see the display you want, then hold the knob
for two seconds. The radio will produce one beep and
selected display will now be the default.
AM FM: Press this button
to
listen
to
the radio when a
CD
is
playing. The CD will stop but remain in the
player.
TAPE CD: Press this button
to
play a tape when
listening
to
the radio. Press this button
to
switch
between the tape and compact disc
if
both are loaded.
The inactive tape or CD will remain safely inside the
radio for future listening.
&I
EJT (Eject): Press this button
to
stop a CD when
it is playing or to eject a CD when it is not playing.
Eject may be activated with either the ignition or radio
off. CDs may be loaded with the radio and ignition
off
if
this button is pressed first.
Compact
Disc
Messages
If the disc comes out, it could be for one of the following
reasons:
You’re driving on a very rough road. When the road
becomes smoother the disc should play.
It’s
very hot. When the temperature returns
to
The disc is dirty, scratched, wet or upside down.
normal, the disc should play.
The air is very humid. If
so,
wait about an hour and
try again.
If
the CD is not playing correctly, for any other reason,
try a known good CD.
If
any error occurs repeatedly or
if
an error can’t be
corrected, contact your dealer.
3-80
To Next Page
Loading...
