The air inflator kit may be located in the glove
box.
The kit includes a 22 ft (6.7 m) hose with three nozzle
adapters.
To
use the air inflator, attach the appropriate nozzle
adapter
to
the end of the hose
if
required. Then attach
that end of the hose
to
the object you wish
to
inflate.
Attach the other end of the hose
to
the outlet.
To reinstall the cover, line up the tabs at the back of the
cover, put it in place and latch the tabs.
A continuous flashing indicator light may
also
indicate a
malfunction in the air suspension system.
Press and release the switch
to
turn the air inflator on.
The indicator light will remain on when the inflator is Inflating something too r..-ch ca..
...-
ke
it
running. explode, and you or others could be injured.
The system has an internal clock
to
prevent overheating. Be sure to read the inflator instructions, and
The system will allow about five minutes of running inflate any object only to its recommended
time, then the compressor will
stop.
The indicator light
will then begin
to
flash. When the indicator is
off,
the inflator can be started again by pressing the switch.
If the compressor is still hot,
it
may only run for a
short time before shutting
off
again.
Press and release the switch
to
turn the inflator
off.
Place
the inflator kit
tools
in the pouch and store
it
properly.
Remove the inflator hose from the outlet during loading
and unloading. Load leveling will not function with the
inflator hose attached to the inflator outlet.
5-65
To Next Page
Loading...
