Getting to Know Your Yukon/Yukon Denali
12
Memory Positions for Driver’s
Seat, Mirrors, Pedals, Radio and
Climate Controls (if equipped)
Use the driver’s
door mounted con-
trols to:
• Adjust driver
seat, including
lumbar
adjustment
• Adjust gas and
brake pedals
• Adjust the outside rearview mirrors
• Set the radio presets and climate
control temperature (the temperature
setting will revert to the last tempera-
ture setting used)
• Press and hold Memory 1 or 2 until
two chimes sound (about four
seconds)
•To set up for another driver, repeat
the process with the other memory
button
These settings will be remembered after
they are programmed by pressing the
Memory 1 or 2
button on the
driver’s door
(shown above).
If you unlock the
vehicle with the
Remote Keyless
Entry (RKE)
transmitter, the
vehicle memory
settings will correspond to the number
on the RKE transmitter: 1 or 2.
See Section 2 of your Owner Manual.
Memory Settings for Your
Vehicle (Driver Information
Center) (if equipped)
Your vehicle may be programmed with
the features shown below. To cycle
through them, use the
Personalization/Menu button ( )
located on your steering wheel.
• Alarm Warning Type
• Automatic Locking/Unlocking
• Perimeter Lighting
• Delayed Locking
• Remote Lock/Unlock Feedback
• Seat Position Recall
• Headlamps On at Exit
• Easy Exit Driver Seat
• Display Units
• Display Language
• Curb View Assist (if equipped)
Selection Options
Use the Select button ( ) to choose
your desired setting. The last setting
remaining on the display will be
the selection of choice. Continue
cycling through the menu with the
Personalization/Menu button ( )
to set other preferences.
Alarm W
arning Type
1. Alarm Warning: Both (default)
2. Alarm Warning: Off
3. Alarm Warning: Horn
4. Alarm Warning: Lamps
To Next Page
Loading...
