Headlamps
1. Your vehicle is equipped with two pins, remove the
two pins on the top of the headlamp assembly.
To remove the pins, turn the outer pin outward and
pull it straight up. To remove the inner pin, turn
it in and pull it straight up.
A. Low-Beam Headlamp
B. High-Beam Headlamp
2. Pull the headlamp assembly out.
3. Unplug the electrical connector.
4. Turn the old bulb counterclockwise and remove it
from the headlamp assembly.
5. Put the new bulb into the assembly and turn it
clockwise until it is tight. Use care not to touch
the bulb with your fingers or hands.
6. Plug in the electrical connector.
7. Put the headlamp assembly back into the vehicle.
Install and tighten the two pins.
5-57
To Next Page
Loading...
