Removing the Bench Seat
To remove the seat, do the following:
1. Open the liftgate to access the controls for the
bench seat and enter the rear of the vehicle.
2. Fold the seatback forward using the instructions
listed under “Folding the Seatback” previously.
The seat cannot be removed unless the seatback
is folded.
3. Pull up on the release
lever labeled 2, located
at the rear of the
seat, to unlatch the
rear of the seat
from the floor.
4. Lift the rear of the seat up from the floor.
5. Pull on the release
strap, located in the
lower center of
the seat, to release
the seat from the
floor and pull the
seat out. Use one
hand to pull the
release strap and the
other on the handle
to pull the seat out.
6. While holding the rear of the seat up, roll the seat
out of the vehicle.
1-21
To Next Page
Loading...
