Reprogramming a Single Universal
Home Remote Button
To program a device to Universal Home Remote
using a Universal Home Remote button
previously trained, follow these steps:
1. Press and hold the desired Universal Home
Remote button. Do not release the button.
2. The indicator light will begin to flash after
20 seconds. While still holding the Universal
Home Remote button, proceed with Step
2 under “Programming Universal Home
Remote” shown earlier in this section.
For additional information on Universal Home
Remote, see Customer Assistance Offices
on page 575.
Storage Areas
Glove Box
Open the glove box by pulling the bottom of the
handle upward.
Cupholder(s)
Your vehicle may have cupholders located in the
front and rear of the floor console or in the fold
down armrest. The front cupholders can be
adjusted by moving the insert forward or rearward.
You may also have cupholders in the second and
third row seat armrest areas.
To access the cupholders in the rear floor console,
pull downward on the lid.
174
To Next Page
Loading...
