GMC 2010 Acadia - Page 235

Infotainment System 7-47
When to Speak: A short tone
sounds after the system responds
indicating when it is waiting for a
voice command. Wait until the tone
and then speak.
How to Speak: Speak clearly in a
calm and natural voice.
Audio System
When using the in‐vehicle Bluetooth
system, sound comes through
the vehicle's front audio system
speakers and overrides the audio
system. Use the audio system
volume knob, during a call, to
change the volume level. The
adjusted volume level remains in
memory for later calls. To prevent
missed calls, a minimum volume
level is used if the volume is turned
down too low.
Bluetooth Controls
Use the buttons located on the
steering wheel to operate the
in‐vehicle Bluetooth system.
See Steering Wheel Controls
on
page 5‑2
for more information.
b g (Push To Talk) : Press to
answer incoming calls, to confirm
system information, and to start
speech recognition.
c x (Phone On Hook): Press to
end a call, reject a call, or to cancel
an operation.
Pairing
A Bluetooth enabled cell phone
must be paired to the in‐vehicle
Bluetooth system first and then
connected to the vehicle before it
can be used. See the cell phone
manufacturers user guide for
Bluetooth functions before pairing
the cell phone. If a Bluetooth phone
is not connected, calls will be made
using OnStar
®
Hands‐Free Calling,
if available. Refer to the OnStar
owner's guide for more information.
Pairing Information:
.
Up to five cell phones can be
paired to the in‐vehicle Bluetooth
system.
.
The pairing process is disabled
when the vehicle is moving.
.
The in‐vehicle Bluetooth system
automatically links with the first
available paired cell phone in the
order the phone was paired.
.
Only one paired cell phone can
be connected to the in‐vehicle
Bluetooth system at a time.
.
Pairing should only need to be
completed once, unless changes
to the pairing information have
been made or the phone is
deleted.
To link to a different paired phone,
see Linking to a Different Phone
later in this section.