2-4 Keys, Doors and Windows
If enabled through the DIC, the
parking lamps flash twice to indicate
unlocking has occurred. See Vehicle
Personalization (With DIC Buttons)
on page 5‑45
.
Pressing
K on the RKE transmitter
disarms the content theft‐deterrent
system. See Anti-Theft Alarm
System on page 2‑13.
& (Power Liftgate): Press
and hold until the liftgate begins to
move to open or close the liftgate.
The taillamps flash and a chime
sounds to indicate when the liftgate
is opening or closing.
L (Vehicle Locator/Panic
Alarm): Press and release to
locate the vehicle. The parking
lamps flash and the horn sounds
three times.
Press and hold
L for more than
two seconds to activate the panic
alarm. The parking lamps flash and
the horn sounds repeatedly for
30 seconds. The alarm turns off
when the ignition is moved to
ON/RUN or
L is pressed again.
The ignition must be in LOCK/OFF
for the panic alarm to work.
The vehicle comes with two
transmitters. Each transmitter will
have a number on it, "1" or "2".
These numbers correspond to
the driver of the vehicle. For
example, the memory seat position
for driver 1 will be recalled when
using the transmitter labeled "1",
if enabled through the vehicle
personalization. See “Memory Seat
and Mirrors” under Power Seat
Adjustment
on page 3‑4
and
“Memory Seat Recall” under Vehicle
Personalization (With DIC Buttons)
on page 5‑45
for more information.
Programming Transmitters to
the Vehicle
Only RKE transmitters programmed
to this vehicle will work. If a
transmitter is lost or stolen, a
replacement can be purchased
and programmed through your
dealer/retailer. When the
replacement transmitter is
programmed to this vehicle using
the DIC, all remaining transmitters
must also be reprogrammed.
Any lost or stolen transmitters
will no longer work once the
new transmitter is programmed.
Each vehicle can have up to
eight transmitters programmed to it.
See “Relearn Remote Key” under
Driver Information Center (DIC)
(With DIC Buttons)
on page 5‑24
or Driver Information Center (DIC)
(Without DIC Buttons)
on
page 5‑29
for instructions on how
to program transmitters to this
vehicle.
To Next Page
Loading...
