10-64 Vehicle Care
21. Dispose of the used sealant
canister (E) and sealant/air
hose (F) assembly at a local
dealer/retailer or in accordance
with local state codes and
practices.
22. Replace it with a new
canister available from your
dealer/retailer.
23. After temporarily sealing a tire
using the tire sealant and
compressor kit, take the
vehicle to an authorized
dealer/retailer within a
100 miles (161 km) of driving
to have the tire repaired or
replaced.
Using the Tire Sealant and
Compressor Kit without
Sealant to Inflate a Tire
(Not Punctured)
To use the air compressor to inflate
a tire with air only and not sealant:
Always do a safety check first. See
If a Tire Goes Flat
on page 10‑57
.
1. Remove the tire sealant and
compressor kit from its storage
location. See Storing the Tire
Sealant and Compressor Kit
on
page 10‑66
.
2. Unwrap the air only hose (G)
and the power plug (H).
3. Place the kit on the ground.
Make sure the tire valve stem is
positioned close to the ground
so the hose will reach it.
To Next Page
Loading...
