Seats and Restraints 3-29
2. Place the guide over the belt
and insert the two edges of the
belt into the slots of the guide.
3. Be sure that the belt is not
twisted and it lies flat. The
elastic cord must be under the
belt and the guide on top.
{
WARNING
A safety belt that is not properly
worn may not provide the
protection needed in a crash.
The person wearing the belt
could be seriously injured.
(Continued)
WARNING (Continued)
The shoulder belt should go over
the shoulder and across the
chest. These parts of the body
are best able to take belt
restraining forces.
4. Buckle, position, and release
the safety belt as described
previously in this section. Make
sure that the shoulder belt
crosses the shoulder.
To Next Page
Loading...
