Vehicle Care 10-95
1. Put the tire on the ground at
the rear of the vehicle with the
valve stem pointed down, and to
the rear.
2. Pull the cable and spring
through the center of the wheel.
Tilt the wheel retainer plate
down and through the center
wheel.
Make sure the retainer is fully
seated across the underside of
the wheel.
3. Attach the wheel wrench (H)
and extensions (I) together,
as shown.
4. Insert the hoist end (F) through
the hole (G) in the rear bumper
and onto the hoist shaft.
Do not use the chiseled end of
the wheel wrench.
5. Raise the tire part way upward.
Make sure the retainer is seated
in the wheel opening.
To Next Page
Loading...
