10-38 Vehicle Care
Taillamps, Turn Signal,
Stoplamps, and Back-Up
Lamps
A. Stoplamp/Taillamp
B. Turn Signal/Taillamp
C. Back-up Lamp
To replace one of these bulbs:
1. Remove the two screws from
the taillamp assembly.
2. Remove the taillamp assembly
by pulling rearward until the
two outboard pins of the taillamp
disengage from the vehicle.
3. Press the release tab,
if equipped, and turn the socket
counterclockwise to remove it
from the taillamp assembly.
4. Pull the old bulb straight out
from the socket.
5. Press a new bulb into the
socket, insert the socket into
the taillamp assembly and turn
the socket clockwise into the
taillamp assembly until it clicks.
6. Reinstall the taillamp assembly.
To Next Page
Loading...
