GMC CANYON 2024 - Keyless (Push-Button) Start; Electric Parking Brake

5
The Remote Keyless Entry transmitter (key fob) must be in the vehicle to turn on the
ignition.
STARTING THE ENGINE/ON
With the transmission in Park or
Neutral, press the brake pedal and then
press the ENGINE START/STOP button
to start the engine. The green button
indicator will illuminate.
Note: If the key fob battery is weak, place the
key fob in the right cupholder in the center
console to enable the engine to start. Replace
the key fob battery as soon as possible.
STOPPING THE ENGINE/OFF
Shift to Park and then press the ENGINE START/STOP button to turn o the engine.
ACCESSORY MODE
With the engine o and the brake pedal not applied, press the ENGINE START/
STOP button to place the ignition in Accessory Mode. The amber button indicator
will illuminate.
See Driving and Operating in your Owner’s Manual.
KEYLESS (PUSH-BUTTON) START
AUTO ENGINE STOP/START OPERATION
ELECTRIC PARKING BRAKE
The fuel-saving Engine Stop/Start system automatically turns o the engine, referred
to as an Auto Stop, when the brake pedal is applied and the vehicle is at a complete
stop, if certain operating conditions are met. When stopped, the
$
displays in the
Driver Information Center. The engine may remain running or restart when the vehicle
is stopped, depending on current operating conditions. When the brake pedal is
released or the accelerator pedal is pressed, the engine will restart.
AUTO STOP DISABLE
Press the
$
Auto Stop button on the center of the instrument panel. The button
indicator will turn o.
The Engine Stop/Start system is enabled each time the vehicle is started.
See Driving and Operating in your Owner’s Manual.
To apply the parking brake, pull the Parking Brake switch on the center
console.
To release the parking brake, turn on the ignition, press the brake pedal, and then
press the switch.
See Driving and Operating in your Owner’s Manual.
Some equipment shown may not be included in your vehicle.